How To Tie In A New Roof To An Existing Roof

How To Tie In A New Roof To An Existing Roof

How To Tie In A New Roof To An Existing Roof

How To Tie In A New Roof To An Existing Roof. The lower the slope the further it should extend. When adding a new roof to an existing one, an inspection of the old one is necessary.

How To Tie In A New Roof To An Existing RoofHow To Tie In A New Roof To An Existing Roof
Tying An Addition Roof To An Existing House | My Diy – Youtube from www.youtube.com

Chip away the existing gravel, exposing the stone underneath. What you need to do is create a centerline, an area where the new roof is going to start. It helps in protecting the roofs.

The Roof I Am Working On In This Project Is A 4Ply Built Up System With Gravel On It.

Make sure to include the 6 inches edge into the counting. How to tie in a roof to an existing roof. Make it to the extent of around 6 inches from the edge of every pitch.

See also  Toby Keith Movies List

To Tie Into Existing Roof Shingles Use A Cut Valley.

How to tie in a roof to an existing roof. When adding a new roof to an existing one, an inspection of the old one is necessary. Frame and sheathe the addition roof, and snap a line on the existing shingles 2 inches above the valley.

Fold New Shingles Over The New Valley Onto The Old Roof, Overlapping By At Least A Foot.

The new flashing should go under the old felt and over the new felt and new roll roofing. When the top of a roof is worn out, it will leave the framing intact. Select an edge of the roof that you want to join, and then select the wall or roof to which you want to join the roof crossbars:

The Easiest Way To Tie In The New Shingles With The Old Is With A Cut Valley (See Four Ways To Shingle A Valley).

Finish the new roof by nailing on osb sheathing, covering it with roofing paper and nailing in metal flashing along the valleys and metal drip edge at the eaves. If you want to give support with a simple post, then decide the location first. If you want to give support with a simple post, then decide the location first.

How To Tie In A Roof To An Existing Roof.

How to tie in a roof to an existing roof. Place the flashing material at the meeting point. Asbestos roofing sheets polycarbonate or plastic commonly used in skylights roof lights, particularly those in the roof.

See also  Can My Lg Remote Control My Soundbar

Leave a Reply

Your email address will not be published.