How To Measure Golf Club Length For Height. Check below golf club size guide for men. Taking your golf club measurements can be completed in a couple of ways:
As you can see in our golf club size chart above these would typically fit in the 34″ to 35.5″ range. In your normal playing position. Place the shaft flat against the wall with the toe driver on the ground.
Table of Contents
So, You Will Get Either 1/8” More Or 1/8” Less, If Any Of The Above Two Things Happen.
Grab the club in your hands. You’ll get a more accurate measurement if you measure your club while it’s horizontal than if you held it vertically. What are standard length golf clubs?
Raise And Lower The Grip Until The Sole Of The Club Lies Flat On The Ground.
Hold the ruler as though it’s a golf club at address. Use the dial to measure the distance between the end of the shaft and the end of the grip. You will need to add 1/2 inch (1.3 cm).
You Will Get A Reading Of 1/8″ More Or Less Than The Accurate Result In These Two Cases.
This is for your reference only. Now measure the golf club’s length using a measuring tape from the cap of the grip to the ground. As a very general rule, you should add between 1/4 and 1/2 inch of length to your club for every inch taller you are than a club’s standard size.
Here You’ll Find The Standard Recommended Measurements For Golf Clubs Based On Height:
The final length is measured at the edge of the. Lay the club flat so that the toe of the club faces directly up. 11 rows golf club length chart.
A Measuring Tape Or A Standard Golf Club Is A Measuring Ruler.
Place the ruler on the edge of the club and measure it properly. Taking your golf club measurements can be completed in a couple of ways: In your normal playing position.